The length of bolt or screw is different in terms of assembly parts
and protective plate. It should be installed in the right position, if
confused, place the bolt into the hole to check whether it fits or
not.
When installing the oil seal, please fill the grease lubricant into
the oil seal groove, and check the oil seal is smooth or not,
otherwise it may damage the oil seal.
When installing the rubber hose (fuel oil, vacuum or coolant), the
end of the rubber hose shall be inserted into the connection
bottom, so that the hose clamp has enough space to grip the
connection. The rubber of plastic dust cover shall be put into the
original design position.
Disassembly of ball bearing: use the instrument to withstand one
or two (inside and outside) bearing race ring. If the strength is
only used on one race ring (no matter inside or outside), it may
cause damage to bearing when disassembling and the bearing has
to be replaced.
To Next Page
Loading...
Need help?
General
