The loose cable is the potential electric safety hazard. After
clamping the cable, please check the following one to ensure
the electric safety;
The wire clip is not allowed to bend towards the welding spot
direction;
Please bind the cables at the specified position；
The cable can not be routed on the end or closed angle of the
frame;
The cable can not be routed on the end of bolt or screw;
The cable routing shall be kept away from a heat source or
the place which may clip the cable when moving;
Over tightening or over loosening shall be avoided when the
cable is routed along the cocket handle, and no contacting
with the adjacent components in any steering position;
The cable routing shall be smooth without twisting or
knotting;
Please confirm if there is any damage to the connector
assembly sheath or any excessive expansion of the connector
assembly before the butt joint of the onnector assembly;
If the cable is placed on the closed angle or corner, please use
tape or hose to protect;
Please use the tape to wrap the cable after repairing;
The control wire shall be free from twisting or knotting. Any
damage to the control wire may cause inadequate control;
To Next Page
Loading...
