Sweep limitations ............................................................... F-6
Staircase and custom sweeps ...................................... F-6
Source memory sweeps ............................................... F-6
Limit test sequence ............................................................. F-7
Binning failure indications (grading mode) ..................... F-10
Auto clear on, end binning ........................................ F-10
Auto clear on, immediate binning ............................. F-10
Auto clear off, end binning ....................................... F-10
Auto clear off, immediate binning ............................ F-11
Front panel contact check operation ........................................ F-11
Menu selections ................................................................ F-11
Using contact check ......................................................... F-12
Using event detection with contact check ................. F-13
Using pass/fail with contact check ............................ F-13
Remote contact check operation .............................................. F-14
Contact check remote commands ..................................... F-14
Contact check programming example .............................. F-16
Contact check command reference .......................................... F-17
Configure and control contact check ................................ F-17
CCHeck <b> ............................................................. F-17
RESistance <NRf> .................................................... F-17
Configure and control contact check limit test ................. F-17
STATe <b> ................................................................. F-17
FAIL? ........................................................................ F-18
SOURce2 <NRf> |<NDN> ....................................... F-18
Configure and control contact check event detection ....... F-19
SOURce <name> ...................................................... F-19
TOUT <NRf> ............................................................ F-20
Contact check defaults ............................................................. F-20
G GPIB 488.1 Protocol
Introduction ............................................................................... G-2
Selecting the 488.1 protocol ...................................................... G-2
Protocol differences ................................................................... G-3
Message exchange protocol (MEP) .................................... G-3
Using SCPI-based programs .............................................. G-3
NRFD hold-off ................................................................... G-4
NDAC hold-off ................................................................... G-4
Trigger-on-talk ................................................................... G-5
Message available ............................................................... G-5
General operation notes ...................................................... G-5
GPIB reading speed comparisons .............................................. G-6
Sweep operation ................................................................. G-6
Single-shot operation .......................................................... G-8
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com