2400 Series SourceMeter
®
User’s Manual Basic Source-Measure Operation 3-13
Front panel source delay
To set the manual source delay from the front panel:
1. Press CONFIG then SOURCE V.
2. Select DELAY from the displayed choices, then press ENTER.
3. Enter the desired DELAY value, then press ENTER.
4. Press EXIT to return to normal display.
To set the auto source delay state from the front panel:
1. Press CONFIG then SOURCE V.
2. Select AUTO DELAY from the displayed choices, then press ENTER.
3. Select ENABLE or DISABLE as desired, then press ENTER.
4. Press EXIT to return to normal display.
Remote command source delay
Use the :SOURce:DELay or :SOURce:DELay:AUTO commands to program the source
delay via remote. (See Section 18, “Set delay,” for details.) For example, the following
command sets the source delay to 500ms:
:SOUR:DEL .5
Similarly, send the following command to enable auto delay:
:SOUR:DEL:AUTO ON
Table 3-4
Auto source delay
2400
I-range
2410
I-range
2420
I-range
2425/2430
I-range
2440
I-range
Auto delay
(Source V)
Auto delay
(Source I)
1µA
10µA
100µA
1mA
10mA
100mA
1A
1µA
10µA
100µA
1mA
20mA
100mA
1A
10µA
100µA
1mA
10mA
100mA
1A
3A
10µA
100µA
1mA
10mA
100mA
1A
3A/10A*
10µA
100µA
1mA
10mA
100mA
1A
5A
3msec
2msec
1msec
1msec
1msec
1msec
1msec
3msec
1msec
1msec
1msec
1msec
1msec
2msec
*10A range only on Model 2430.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
