Table 18-10 TRACe command summary ............................................... 18-21
Table 18-11 TRIGger command summary ............................................. 18-22
B Status and Error Messages
Table B-1 Status and error messages ..................................................... B-3
D IEEE-488 Bus Overview
Table D-1 IEEE-488 bus command summary ........................................ D-7
Table D-2 Hexadecimal and decimal command codes ........................ D-10
Table D-3 Typical addressed multiline command sequence ................ D-12
Table D-4 Typical addressed common command sequence ................. D-12
Table D-5 IEEE command groups ....................................................... D-13
Table D-6 SourceMeter interface function codes ................................. D-14
E IEEE-488 and SCPI Conformance Information
Table E-1 IEEE-488 documentation requirements ................................ E-3
Table E-2 Coupled commands ............................................................... E-4
F Contact Check Function
Table F-1 Recommended contact resistance threshold values .............. F-5
Table F-2 Contact check menu selections ........................................... F-11
Table F-3 Contact check remote commands ........................................ F-14
Table F-4 Contact check programming example ................................. F-16
Table F-5 Contact check defaults ........................................................ F-20
G GPIB 488.1 Protocol
Table G-1 SCPI/488.1 reading speed comparisons
for measure-only sweep operation (rdgs/sec) ....................... G-6
Table G-2 SCPI/488.1 reading speed comparisons
for source-measure sweep operation (rdgs/sec) .................... G-6
Table G-3 SCPI/488.1 reading speed comparisons
for source-measure-limit test sweep operation (rdgs/sec) ..... G-7
Table G-4 SCPI/488.1 reading speed comparisons
for source-memory sweep operation (rdgs/sec) .................... G-7
Table G-5 SCPI/488.1 reading speed comparisons
for measure-only single-shot operation (rdgs/sec)..................G-8
Table G-6 SCPI/488.1 reading speed comparisons
for source-measure single-shot operation (rdgs/sec) ............. G-8
Table G-7 SCPI/488.1 reading speed comparisons
for source-measure-limit test single-shot
operation (rdgs/sec) ............................................................... G-8
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Need help?
General
