M
Manual ranging 7-3
Math 8-4
Built-in functions 8-4
Front panel operation 8-6
Programming example 8-8
Remote operation 8-7
User-defined functions 8-9
Measure only
Front panel operation 3-20
Programming example 3-21
Remote operation 3-21
Measure voltage or current 3-20
Menus 1-20
Configuration 1-26
Main 1-20
Measurement configuration 1-27
Navigating 1-24
Output and display configuration 1-33
Rel, filter, and limit configuration 1-29
Source and range configuration 1-28
Sweep, digits, speed, and data store
configuration 1-32
Sweep, digits, speed, and output
configuration 1-34
Trigger configuration 1-31
Message
Program 14-15
Response 14-17
Status and error B-2
Message exchange protocol 14-17
Multiple-element device binning 12-15
N
NPLC caching 3-10
O
Offset-compensated ohms (math function) 8-4
Ohms
6-wire measurements 4-11
Auto measurements 4-4
Configuration menu 4-2
Enabling/disabling offset
compensation 4-9
Guard 2-9, 6-35
Manual measurements 4-5
Measurement methods 4-3
Measurements 4-1
Offset-compensated 4-9
Programming example 4-13
Remote programming 4-12
Selecting measurement method 4-4
Sensing 4-7
Source readback 4-11
Operating boundaries 6-14
Current compliance 6-28
Duty cycle 6-14
I-Source 6-21
Source or sink 6-14
Voltage compliance 6-24
V-Source 6-26
Operation
Considerations 3-9
Contact check function F-4
Front panel GPIB 14-9
GPIB 14-4
Limit testing 12-5
Math 8-4
Overview 3-3
Pulse Mode 5-1
Remote vs. local 14-2
RS-232 interface 14-18
Sink 3-22
Sweep 10-1
Options 1-3
Output configuration
Commands 13-11
Front panel operation 13-7
Programming example 13-12
Remote operation 13-11
Output-off states 13-8
Overheating
Conditions 6-6
Power equations to avoid shutdown 6-7
Protection 6-6
Overview 1-5
P
Percent deviation (math function) 8-6
Power (math function) 8-4
Power-up sequence 1-11
Primary address 14-6
Probes
General purpose 1-3
Low thermal 1-4
Program messages 14-15
Programming syntax 14-11
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com