F
Factory default settings 1-17
Filter 7-9
Front panel control 7-10
Programming example 7-13
Remote programming 7-12
Front panel operation
Auto zero 3-9
Compliance limit 3-7
Contact check function F-11
Data store 9-2
Digital output control 13-4
Filter 7-10
GPIB 14-9
Guard selection 2-12
Limit testing 12-21
Line frequency 1-12
Math 8-6
Measure only 3-20
Menus 1-20
Output configuration 13-7
Pulse Mode configuration 5-10
Pulse Mode sweep procedure 10-33
Relative 8-2
Sense selection 2-11
Source delay 3-13
Source-measure procedure 3-14
Speed control 7-7
Sweep 10-14
Terminals selection 2-2
Triggering 11-2
V-source protection 3-12
Front panel summary 1-7
Front panel tests 1-16
Front/rear terminals selection 2-2
Fuse replacement 1-13
G
GET (group execute trigger) 14-8
Getting started 1-1
GPIB
Connections 14-4
Front panel operation 14-9
Operation 14-4
Primary address 14-6
Protocol differences G-3
Protocol selection G-2
Reading speed comparisons G-6
Standards 14-4
Status indicators 14-9
GPIB protocol G-1
Grading mode limits operation 12-5
GTL (go to local) 14-8
Guard 6-34
Cable 2-8, 6-34
Methods 2-8
Ohms 2-9, 6-35
Selection 2-12
Sense 6-38
Sense selection 2-11
H
Handler
Interface 12-11
Types 12-12
I
IEEE-488 bus
Commands D-7
Description D-3
Interface function codes D-14
Lines D-5
Overview D-1
IEEE-488 conformance E-1
IFC (interface clear) 14-7
Inspection 1-3
I-Source operating boundaries 6-21
L
Limit 1 test (compliance) 12-3
Limit 2 (course limits) 12-2
Limit testing 12-1
Binning 12-4
Configuring 12-19
Data flow 12-3
Front panel operation 12-21
Grading mode 12-5
Modes 12-4
Operation 12-5
Pass/fail information 12-3
Programming example 12-24
Remote operation 12-23
Sorting mode 12-9
Types 12-2
Limits 3, 5-12 (fine limits) 12-2
Line power
Connection 1-10
Frequency 1-12
Linear staircase sweep 10-2, 10-17
LLO (local lockout) 14-8
LOCAL key 14-10
Logarithmic staircase sweep 10-4, 10-18
Long-form and short-form versions 14-14
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com