EasyManuals Logo

Keithley SourceMeter 2420 User Manual

Keithley SourceMeter 2420
594 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #587 background imageLoading...
Page #587 background image
Remote programming
Data store 9-6
Display 1-15
Filter 7-12
Math 8-7
Ohms 4-12
Range and digits 7-5
Relative 8-3
Speed 7-8
Sweeps 10-22
REN (remote enable) 14-7
Response messages 14-17
RS-232 interface
Baud rate 14-18
Connections 14-19
Data bits and parity 14-18
Flow control (signal handshaking) 14-19
Operation 14-18
Programming example 14-21
Sending and receiving data 14-18
Terminator 14-19
S
Safety interlock 13-5
Safety symbols and terms 1-2
SCPI
Command reference 18-1
Command summary 17-2
Conformance E-1
Eliminating common errors B-8
SCPI commands see Command reference, Com-
mand summary, Common commands, and
Signal-oriented measurement commands
SDC (selective device clear) 14-8
Sensing 2-5
2-wire local 2-7
4-wire remote 2-6
Guard 2-9, 6-38
Ohms 4-7
Selection 2-11
Serial polling 15-9
Settings
Default 1-16
Factory default 1-17
Power-on configuration 1-17
Remote setups 1-20
Restoring 1-16
Saving 1-16
Short-form rules 14-14
Signal-oriented measurement commands
:CONFigure:<function> 17-2
:FETCh? 17-3
:MEASure[:<function>]? 17-5
:READ? 17-4
[:SENSe[1]]:DATA[:LATest]? 17-4
Single-element device binning 12-14
Sink operation 3-22
Programming example 3-24
Source delay 3-12
Source I measure I and source V measure
V 6-30
Source memory sweep 10-7, 10-21, 10-25
Source-delay-measure cycle 6-10
Source-measure capabilities 3-3
Source-measure procedure
Front panel operation 3-14
Remote operation 3-18
SPE, SPD (serial polling) 14-9
Specifications A-1
Speed 7-7
Programming example 7-9
Remote programming 7-8
Setting 7-7
Status and error messages 1-15
Status byte and service request (SRQ) 15-2,
15-7
Status byte and service request
commands 15-10
Status register sets 15-2, 15-11
Store (data) 9-2
Sweep
Configuring and running 10-14
Contact check function F-6
Customized 10-5, 10-19, 10-24
Front panel operation 10-14
Linear staircase 10-2, 10-17, 10-22
Logarithmic staircase 10-4, 10-18,
10-22
Programming example 10-22, 10-25,
10-26
Pulse Mode (Model 2430 only) 10-32
Remote operation 10-22
Source memory 10-7, 10-21, 10-25
Types 10-2
Sweep waveforms 6-12
System identification 1-11
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Table of Contents

Other manuals for Keithley SourceMeter 2420

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keithley SourceMeter 2420 and is the answer not in the manual?

Keithley SourceMeter 2420 Specifications

General IconGeneral
BrandKeithley
ModelSourceMeter 2420
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals