KEM MKC-710 - Page 36

3. Basic operation
26
Note
Do not use the Auto Solvent Change Unit for those samples which are hard to
dissolve or insoluble in solvent in order to avoid clogging of drain tube. Such
waste liquids, if spilled, after measurement may corrode the tube connectors
causing the Auto Solvent Change Unit malfunction.
Note
Change the connecting of the Auto Solvent Change Unit for those samples
which are oily in order to avoid damage of drain tube.
＜Drain＞
1) Press Drain Pump [On] key to drain
waste liquid.