141
Keysight InfiniiVision 3000 X-Series Oscilloscopes
User's Guide
10 Triggers
Adjusting the Trigger Level / 142
Forcing a Trigger / 143
Edge Trigger / 144
Edge then Edge Trigger / 146
Pulse Width Trigger / 147
Pattern Trigger / 150
OR Trigger / 153
Rise/Fall Time Trigger / 154
Nth Edge Burst Trigger / 155
Runt Trigger / 157
Setup and Hold Trigger / 159
Video Trigger / 160
USB Trigger / 172
Serial Trigger / 174
A trigger setup tells the oscilloscope when to acquire and display data. For
example, you can set up to trigger on the rising edge of the analog channel 1 input
signal.
You can adjust the vertical level used for analog channel edge detection by
turning the Trigger Level knob.
In addition to the edge trigger type, you can also set up triggers on rise/fall times,
Nth edge bursts, patterns, pulse widths, runt pulses, setup and hold violations, TV
signals, USB signals, and serial signals (if option licenses are installed).
You can use any input channel or the "External Trigger Input" on page 180 BNC as
the source for most trigger types.
To Next Page
Loading...
Need help?
General
