Waveform Generator 17
Keysight InfiniiVision 3000 X-Series Oscilloscopes User's Guide 263
3 Use the Amplitude/High-Level and Offset/Low-Level softkeys to set the voltage
bounding parameter of the arbitrary waveform.
4 When you are ready to create the new arbitrary waveform, press Apply & Edit.
The new waveform is created and the Edit Waveform Points menu is opened.
See "Editing Existing Arbitrary Waveforms" on page 263.
Note that you can also create a new arbitrary waveform by capturing another
waveform. See "Capturing Other Waveforms to the Arbitrary Waveform" on
page 265.
Editing Existing Arbitrary Waveforms
The Edit Waveform Points Menu is opened by pressing Edit Existing in the Edit
Waveform Menu or by pressing Apply & Edit when creating a new arbitrary
waveform.
When you create a new arbitrary waveform, the existing arbitrary waveform definition is
overwritten. Note that you can use the [Save/Recall] key and menu to save arbitrary
waveforms to one of four internal storage locations or to a USB storage device, and you
can recall them later. See "To save arbitrary waveforms" on page 279 and "To
recall arbitrary waveforms" on page 283.
To Next Page
Loading...
Need help?
General
