Save/Recall (Setups, Screens, Data) 18
Keysight InfiniiVision 3000 X-Series Oscilloscopes User's Guide 281
• Spell — press this softkey and turn the Entry knob to select the character at
the current position.
• Enter — press this softkey to enter characters and move the cursor to the next
character position. Pushing the Entry knob is the same as pressing the Enter
softkey.
• Delete Character — press this softkey to delete the character at the current
position.
When available, the Increment softkey can be used to enable or disable
automatically incremented file names. Auto increment adds a numeric suffix to
your file name and increments the number with each successive save. It will
truncate characters as necessary when the file name length is at maximum and
more digits are required for the numeric portion of the file name.
Recalling Setups, Masks, or Data
1 Press the [Save/Recall] key.
2 In the Save/Recall Menu, press Recall.
3 In the Recall Menu, press Recall:, then, turn the Entry knob to select the type of
file you want to recall:
• Setup (*.scp) — See "To recall setup files" on page 282.
• Mask (*.msk) — See "To recall mask files" on page 282.
• Reference Waveform data (*.h5) — See "To recall reference waveform files from
a USB storage device" on page 282.
• Arbitrary Waveform data (*.csv) — See "To recall arbitrary waveforms" on
page 283.
You can also recall setups and mask files by loading them using the File Explorer.
See "File Explorer" on page 295.
You can also configure the [Quick Action] key to recall setups, masks, or reference
waveforms. See "Configuring the [Quick Action] Key" on page 307.
You can use a connected USB keyboard instead of using the Spell (and other) character
editing softkeys.
To Next Page
Loading...
Need help?
General
