291
Keysight InfiniiVision 3000 X-Series Oscilloscopes
User's Guide
20 Utility Settings
I/O Interface Settings / 291
Setting up the Oscilloscope's LAN Connection / 292
File Explorer / 295
Setting Oscilloscope Preferences / 297
Setting the Oscilloscope's Clock / 300
Setting the Rear Panel TRIG OUT Source / 300
Performing Service Tasks / 301
Configuring the [Quick Action] Key / 307
Adding an Annotation / 308
This chapter explains oscilloscope utility functions.
I/O Interface Settings
The oscilloscope can be accessed and/or controlled remotely via these I/O
interfaces:
• USB device port on the rear panel (square shaped USB port).
• LAN interface when a LAN/VGA module is installed in the rear panel module
slot.
• GPIB interface when a GPIB module is installed in the rear panel module slot.
To configure the I/O interfaces:
1 On the oscilloscope's front panel, press [Utility].
2 In the Utility Menu, press I/O.
3 In the I/O Menu, press Configure.
To Next Page
Loading...
Need help?
General
