Save/Recall (Setups, Screens, Data) 18
Keysight InfiniiVision 3000 X-Series Oscilloscopes User's Guide 283
A message indicating whether the recall was successful is displayed.
7 If you would like to clear the display of everything except the reference
waveform, press Clear Display.
To recall arbitrary waveforms
Arbitrary waveform files can be recalled from one of four internal (\User Files)
locations or from an external USB storage device.
When recalling arbitrary waveforms (from an external USB storage device) that
were not saved from the oscilloscope, be aware that:
• If the file contains two columns, the second column is automatically chosen.
• If the file contains more than two columns, you are prompted to select which
column to load. Up to five columns are parsed by the oscilloscope; columns
above the fifth are ignored.
• The oscilloscope uses a maximum of 8192 points for an arbitrary waveform. For
more efficient recalls, make sure your arbitrary waveforms are 8192 points or
less.
To recall an arbitrary waveform:
1 Press [Save/Recall] > Recall > Recall:; then, turn the Entry knob to select Arbitrary
Waveform data (*.csv).
2 Press the softkey in the second position and use the Entry knob to navigate to
the file to recall. See "To navigate storage locations" on page 280.
3 Press the Press to Recall softkey.
A message indicating whether the recall was successful is displayed.
4 If you would like to clear the display, press Clear Display.
See Also • "To edit arbitrary waveforms" on page 261
Recalling Default Setups
1 Press the [Save/Recall] key.
2 In the Save/Recall Menu, press Default/Erase.
3 In the Default Menu, press one of these softkeys:
To Next Page
Loading...
Need help?
General
