360 Keysight InfiniiVision 3000 X-Series Oscilloscopes User's Guide
23 CAN/LIN Triggering and Serial Decode
Searching for LIN Data in the Lister
The oscilloscope's search capability lets you search for (and mark) certain types of
LIN data in the Lister. You can use the [Navigate] key and controls to navigate
through the marked rows.
1 With LIN selected as the serial decode mode, press [Search].
2 In the Search Menu, press the Search softkey; then, turn the Entry knob to select
the serial slot (Serial 1 or Serial 2) on which the LIN signal is being decoded.
3 Press Search; then, select from these options:
• ID — Finds frames with the specified ID. Press the Frame ID softkey to select
the ID.
• ID & Data — Finds frames with the specified ID and data. Press the Frame ID
softkey to select the ID. Press the Bits softkey to enter the data value.
• Errors — Finds all errors.
For more information on searching data, see "Searching Lister Data" on page 126.
For more information on using the [Navigate] key and controls, see "Navigating the
Time Base" on page 60.
To Next Page
Loading...
Need help?
General
