361
Keysight InfiniiVision 3000 X-Series Oscilloscopes
User's Guide
24 FlexRay Triggering and
Serial Decode
Setup for FlexRay Signals / 361
FlexRay Triggering / 362
FlexRay Serial Decode / 365
The FlexRay triggering and serial decode option is license-enabled.
Setup for FlexRay Signals
FlexRay signal setup consists of first connecting the oscilloscope to a differential
FlexRay signal using a differential active probe (the Keysight N2792A is
recommended), specifying the signal source, threshold voltage trigger level, baud
rate, and bus type.
To set up the oscilloscope to capture FlexRay signals:
1 Press [Label] to turn on labels.
2 Press [Serial].
3 Press the Serial softkey, turn the Entry knob to select the desired serial bus
(Serial 1 or Serial 2), and press the softkey again to enable decode.
4 Press the Mode softkey; then, select FlexRay mode.
5 Press the Signals softkey to open the FlexRay Signals Menu.
To Next Page
Loading...
