Horizontal Controls 2
Keysight InfiniiVision 3000 X-Series Oscilloscopes User's Guide 59
Found search events are marked with white triangles at the top of the graticule,
and the number of events found is displayed in the menu line just above the sofkey
labels.
To set up searches
1 Press [Search].
2 In the Search Menu, press Search; then, turn the Entry knob to select the search
type.
3 Press Settings, and use the Search Settings Menu to set up the selected search
type.
Setting up searches is similar to setting up triggers:
• For setting up Edge searches, see "Edge Trigger" on page 144.
• For setting up Pulse Width searches, see "Pulse Width Trigger" on
page 147.
• For setting up Rise/Fall Time searches, see "Rise/Fall Time Trigger" on
page 154.
• For setting up Runt searches, see "Runt Trigger" on page 157.
• For setting up Serial searches, see Chapter 10, “Triggers,” starting on page
141 and "Searching Lister Data" on page 126.
Remember that searches use the measurement threshold settings instead of
trigger levels. Use the Thresholds softkey in the Search Menu to access the
Measurement Threshold Menu. See "Measurement Thresholds" on page 234.
To copy search setups
Except for Serial event search setups, you can copy search setups to trigger
setups and vice-versa.
1 Press [Search].
2 In the Search Menu, press Search; then, turn the Entry knob to select the search
type.
3 Press Copy.
4 In the Search Copy Menu:
To Next Page
Loading...
Need help?
General
