Keysight InfiniiVision 3000 X-Series Oscilloscopes User's Guide 19
To specify the print options / 288
To specify the palette option / 288
20 Utility Settings
I/O Interface Settings / 291
Setting up the Oscilloscope's LAN Connection / 292
To establish a LAN connection / 293
Stand-alone (Point-to-Point) Connection to a PC / 294
File Explorer / 295
Setting Oscilloscope Preferences / 297
To choose "expand about" center or ground / 297
To disable/enable transparent backgrounds / 298
To load the default label library / 298
To set up the screen saver / 298
To set AutoScale preferences / 299
Setting the Oscilloscope's Clock / 300
Setting the Rear Panel TRIG OUT Source / 300
Performing Service Tasks / 301
To perform user calibration / 301
To perform hardware self test / 304
To perform front panel self test / 305
To display oscilloscope information / 305
To display the user calibration status / 305
To clean the oscilloscope / 305
To check warranty and extended services status / 306
To contact Keysight / 306
To return the instrument / 306
Configuring the [Quick Action] Key / 307
Adding an Annotation / 308
To Next Page
Loading...
Need help?
General
