18- 14 Keysight N9912-90001 User’s Guide
System Settings
System Configuration
18-
— The right portion of the screen displays Satellite Power Carrier to Noise
(C/No) dBHz values on the tops of the satellite power chart.
— Sync CLock ON OFF Enable and disable the synchronization of the FieldFox
internal clock to the GPS UTC time standard.
— ON The FieldFox clock is synchronized and updated approximately every
second to the time of the GPS clock. Learn how to set the local time zone
on page 18-16.
— OFF
The FieldFox clock is NOT synched with GPS. When set to OFF after
Sync was ON, the date and time does NOT revert back to the settings
before the clock was synchronized.
— Display ON OFF
Enable and disable the GPS display on the FieldFox main
window.
— Lat/Lon Format
Change the format of the GPS display on the FieldFox
screen. Choose from:
— ddd°mm’ ss.sss”
degrees, minutes, seconds (default setting)
— ddd°mm.mmmmm’
degrees, minutes, fractional minutes
— ddd.ddddddd°
decimal degrees
— Elevation Unit
Choose from:
— m
(Meters)
— Feet
GPS Status
With GPS enabled and a device detected, the following is displayed at the top
of the FieldFox screen:
The C/No values returned are not calibrated at the factory or warranted for
accuracy. The numbers retrieved are passed unprocessed directly from the
GPS receiver in use.
The GPS Sync setting has the same restrictions as the Date and Time
setting. Time can be changed BACK no more than once a day and no more
than 6 hours at a time. Learn more on page 18-16.
To Next Page
Loading...
