August 2013 3-48 P/N 06-236530-001
3-2.5.2.4.19 How to Activate Day/Night Operation for SmartOne Smoke Detectors
Purpose: To enable one or more SmartOne smoke detectors to
automatically adjust alarm thresholds by time of day.
Step Action Result
1 Press 0 Key Initiate menu access
2 Enter Password; Press “Enter” Key Gain access to menus
3 Press 3 Key Enter Set-Menu branch
4 Press "Scroll" Key Access additional options
5 Press 4 Key Select “Programming” option
6 Press 1 Key Select “Day/Night” option
7 Press 1 Key Select option to specify range of smoke detectors
to operate in “Set Detectors”
8 Use keypad to enter single address or range of
smoke-detector addresses to operate via
day/night mode.
Press "Enter" Key to confirm selection.
Specify addresses to operate in day / night mode.
9 Press 1 Key and then press "Enter" Key to confirm
selection.
Enable "Day / Night" mode
10 Wait until the “Detectors Deactivated” message
appears on the display.
Number of detectors deactivated shown.
11 Press "Backspace" Key (as required) Exit Menu System
To Next Page
Loading...
