Chapter 2: Front panel programming
106 P/N 3102352-EN • REV 005 • ISS 28DEC18
7. Choose Save (on the Printer menu).
8. Press the Menu button to exit menu mode, or continue programming.
Ethernet card programming
If you are using the optional Ethernet network card (SA-ETH), you must configure the IP
address, subnet mask, and gateway so that it can communicate with the network. Contact your
network administrator to obtain this information or use the default settings. You can also use
the network card to send event information to a central monitoring station, download to the
panel from the configuration utility, or upload and view system reports using the configuration
utility.
Note: If the firmware version of the OH2000 line card (OH-TCP/IP-LC) is earlier than V2.2, set
the Hello Time value to 75 and the line card's line cut timer value to 175.
Network card default settings:
IP: 192.168.001.003
Mask: 255.255.255.000
Gateway: 000.000.000.000
To program network receivers:
1. Display the panel configuration options menu. See “Panel programming” on page 95.
2. Choose IP.
3. Enter the network card’s IP address.
4. Choose MSK.
5. Enter the network card’s subnet mask number.
6. Choose GWY.
7. Enter the network card’s gateway number.
8. Choose Save.
9. Press the Menu button to exit menu mode, or continue programming.
Port CU programming
To communicate with the CU, you must enter the same TCP/IP port number that you defined
in the CU’s TCP IP Port field.
To set the port CU:
1. Display the panel configuration options menu. See “Panel programming” on page 95.
2. Choose Port CU.
3. Enter the TCP/IP port number (1025 to 65535) that you entered in the Configuration Utility.
The default is 2505. (Ports 1 to 1024 are reserved.)
To Next Page
Loading...
