8. Insert the key into the key cylinder,
turn it to the "ON" position and wait
until the glow plug indicator goes
off (Approx. 8 seconds).
If automatic pre-heating is not suf
-
cient, turn and hold the key to the
position "A" (Manual pre-heating)
for a few seconds for manual pre-
heating. During the same seconds,
the glow plug indicator on the dash
board illuminates.
9. When the engine is started, re
-
lease the key. Then, the key is
automatically turned back to the
“ON” position.
10. Warm up the engine for 3 to 4
minutes (10 minutes in winter)
after releasing the clutch pedal.
It is normal that the charge warn
-
ing lamp and engine oil pressure
warning lamps come on when the
key is in “ON” position before the
engine starts.
WARNING
Never operate the start motor
for more than 10 consecu-
tive seconds as it consumes
an excess of battery power. If
the engine cannot be started
within 10 seconds, wait for 30
seconds and try again.
When trying to start the en-
gine again, wait until the fly-
wheel is completely stopped.
•
•
11. Check to see that all the warning
lamps on the instrument cluster
turn “OFF”.
If any lamp remains on, immediately
stop the engine and determine the
cause.
(1) Engine Check Lamp
(2) Engine Oil Pressure Warning Lamp
(3) Charge Warning Lamp
To Next Page
Loading...
