(1) Adjusting Bolt
(A) Adjusting Belt Tension (B) Pull
ADJUSTING FAN BELT TENSION (V)
In order to extend the fan belt’s life-
time, the tension of the belt should
be correctly adjusted if it slips. The
belt tension should be inspected
regularly according to the following
procedure:
1. Stop the engine and apply the
parking brake.
2. Open the hood.
3. In order to measure the belt ten-
sion, apply thumb pressure strong-
ly to the “A” location of belt.
td2O725A
WARNING
Stop the engine when check-
ing the items above.
Inspect the fuel pipe regularly.
The fuel pipes are subject to
wear and aging. Failure to
perform periodic inspections
may lead to a fuel leak. Fuel
leaking on a hot engine could
cause a re.
•
•
IMPORTANT
When disconnecting the fuel
pipe for replacement, plug
both ends with cloth or paper
to prevent dust or foreign ma-
terial from entering it. Other-
wise, the fuel injection pump
can be damaged. Pay extra
caution to the fuel pump to
prevent dust from entering it.
•
3. If the fuel pipes and hose clamps
are found damaged or deterio-
rated earlier than two years, then
change them immediately.
4. After the f uel pipe a nd hose
clamps have been changed, bleed
the fuel system.
To Next Page
Loading...
