6. Front distance should be 2 ~ 8 mm
(0,079 ~ 0,315 in.) less than rear
distance. If not, adjust the length
of the tie rod joint.
td2O728A
Check to ensure the radiator hoses
are free from damage and are tight-
ened properly every 200 hours or ev-
ery 6 months, whichever comes rst.
1. If the hose clamps are loose or wa-
ter leaks from hose, tighten clamps
securely.
2. If the radiator hose is swollen,
hardened, cracked or damaged, it
should be replaced immediately.
Also, it should be replaced every 2
years.
(1) Clamp (2) Radiator Hose
CHECKING RADIATOR HOSE AND CLAMP (Z)
Take the following actions in the
event the coolant temperature reach-
es the boiling point, what is called
"Over-heating".
1. Stop the machine in a safe place
and keep the engine unloaded
idling.
2. After 5 minutes of unloaded idling,
shut the engine down.
3. Keep yourself away from the trac-
tor for another 10 minutes or until
steam has stopped blowing out of
the engine.
4. Make sure that there is no danger
and repair the cause of the over-
heating according to the manual’s
instruction. (Refer to the instruction
in Chapter. Troubleshooting before
starting the engine.)
To Next Page
Loading...
