Kioti DK6010 - Changing Front Axle Case OIL (N)

57
7
-
19
MAINTENANCE
(1) Oil Filler Plug (2) Drain Plug
1. Remove the drain plugs from the
front axle case (LH/RH) and front
axle support to drain oil.
2. After draining, reinstall the drain
plugs securely.
3. Remove the bleeding plug from the
front axle case and add oil through
the ller hole.
td2O714A
CHANGING FRONT AXLE CASE
OIL (N)
IMPORTANT
To prevent serious damage to
the hydraulic system, use only
a KIOTI genuine lter.
Do not operate the tractor
immediately after changing
transmission fluid. Run the
engine at medium speed for a
few minutes to prevent dam-
age to the hydraulic system.
•
•
(1) Oil Dipstick (2) Oil Filler Plug
(A) Oil Level Is Acceptable Within This Range
5. Apply a thin lm of clean oil onto
the O-ring of a new lter.
6. Tighten the lter until it touches the
mounting surface. Then, tighten
the lter for a half turn further with
a hand.
7. After installing a new lter, run the
engine for a few minutes and stop
it.
8. Check the oil level again and add
more oil to the specied level.
td2O704A
Oil Capacity
43 L (11,36 U.S.gal.)
CAUTION
To avoid injury:
Be sure to stop the engine
before changing the fluid or
replacing the lter.
Cool down the uid sufcient-
ly. You can get burnt by hot
uid.
•
•
Oil Capacity [L (U.S. gal)]
Normal type
5,6 (1,48)
Narrow type
4,8 (1,27)
TD210-EEC인증용-DK6010H,DK6010C,DK619 19 2018-12-27 오전 10:30:38