2. Check the length of the jump cable
and position another tractor near
the tractor with the discharged bat-
tery. Then, put all the shift levers in
the neutral position, apply the park-
ing brake, and stop the engine.
3. Wear protective glasses and
gloves and open the hoods of
both tractors. Remove the bat-
tery terminal cover as necessary.
4. Connect the alligator clips on
both ends of the red positive
cable to the positive terminals of
both batteries.
5. Connect one clip of the black
negative cable to the negative
terminal of the normal battery
and the other clip to the tractor
body with the discharged battery.
Make sure to connect the clip to
the body part without paint.
6. Start the engine of the tractor
with the normal battery.
7. Start the engine of the tractor
with the discharged battery.
8. Disconnect the black cable from
the negative battery terminals of
both of the tractors.
9. Disconnect the red cable.
10. Run the engine for at least 30
minutes to charge the discharged
battery.
11. If the battery is discharged again,
replace it or check the charging
system, such as the alternator.
WARNING
Check if the seat is securely
locked after the seat adjust-
ment.
Do not adjust the seat while
driving. The seat may move
suddenly causing the loss of
control of the tractor.
•
•
OPERATING THE TRACTOR
HOW TO DRIVE
1. Adjust the seat and fasten the seat
belt.
(1) Seat Adjustment Lever (Sliding)
(A) Pull
To Next Page
Loading...
