1. The brake and clutch pedals
should be inspected for free travel,
and smooth operation.
2. You should adjust these pedals
if an incorrect measurement is
found. (Refer to the instructions for
adjusting the clutch and brake ped-
als in the Chapter Maintenance.)
CHECKING BRAKE AND CLUTCH
PEDALS (H)
1. Inspect the instrument panel for
broken gauge(s), meter(s) and in-
dicators.
2. Replace if broken.
CHECKING HEAD LIGHT, HAZARD
LIGHT ETC. (J)
1. Inspect the lights for broken bulbs
and lenses.
2. Replace if broken.
CHECKING SEAT BELT AND
CABIN (K)
1.
Always check the condition of the
seat belt and cabin before operating
tractor.
2. Replace if damaged.
CHECKING GAUGES, METER
AND INDICATORS (I)
NOTE
When depressing the brake
pedals separated, both of the
brake pedals should be moved
down to the same depth.
•
IMPORTANT
Bonnet grill and screen must
be clean from debris to pre-
vent engine from overheating
and to allow good air intake
for the air cleaner.
•
To Next Page
Loading...
