td2O731A
FLUSH COOLING SYSTEM AND CHANGING COOLANT (AJ)
1.
Park the tractor on level ground, stop
the engine and let the engine cool down.
2. To drain coolant, remove the drain
plug from the radiator and turn the
radiator cap to the 1st notch to
release pressure in the radiator.
Then, remove the cap completely.
3. After all coolant is drained, t the
drain plug.
4.
Use clean, fresh water and anti-
freeze to ll the reservoir tank.
5. Follow the cleaner manufacture’s
instruction.
(1) Drain Plug
(1) Radiator Cap (2) Reservoir Tank
(A) Full (B) Low
6. Install the radiator cap securely.
7. Start and idle the engine for few
minutes.
8. Stop the engine and let it cool.
9. Drain water and cooling system
cleaner and close drain cock.
Then, fill with antifreeze and
water mixture and close radiator
cap securely.
10. Run tractor at idle until up to op-
erating temperature.
td2O732A
11. Check the coolant level in the
reservoir tank. If the level is low,
add coolant.
CAUTION
To avoid accidents:
Do not remove the radiator cap
while the coolant is hot. Steam
or scalding liquids released
from hot cooling system can
burn you seriously. Cool down
the engine rst.
Even though the coolant is
cooled down, turn the cap to
its rst stop and then wait un-
til it is depressurized before
removing the cap completely.
•
•
Coolant capacity [L (U.S. gal)]
7,9 (2,1)
To Next Page
Loading...
Need help?
General
