BLEEDING FUEL SYSTEM (AK)
(1) Drive Pump (2) Air Plug
td2O733A
Standard
CRDI type
1. Make sure that the amount of fuel
in the fuel tank is sufcient.
2. If air is introduced into the fuel
filter, unscrew the bleeding bolt
(2) shown in the above gure, and
turn the ignition switch to run the
start motor. Then, air in the fuel
filter is bled through the bleeding
bolt as shown in the gure above.
3. When fuel is visible through the
bleeding bolt, tighten the bolt and
start the engine.
NOTE
Bleeding is not necessary if in-
stalling the fuel port after fueling.
•
IMPORTANT
To protect the catalyst filter,
keep the followings:
Make sure to use only speci-
ed fuel.
Keep the engine oil replace
-
ment schedule.
Check the engine oil level fre-
quently to keep it to the speci-
ed level.
Avoid any unnecessary engine
idling.
Never stop the engine during
driving.
Never place the shift lever in
the neutral position when driv-
ing downhill.
Do not use any engine oil ad-
ditive or fuel additive.
Avoid driving with any warn-
ing lamp illuminated.
Do not allow any flammable
materials, such as dry grass
and paper, to come near the
catalyst lter while parked.
•
•
•
•
•
•
•
•
•
To Next Page
Loading...
