HOW TO DEACTIVATE PTO CRUISE
Depress the brake or clutch pedal or
turn off the PTO cruise switch to de
-
activate the function.
If the PTO cruise is deactivated by
depressing the brake or clutch pedal
with the PTO cruise switch in the “ON”
position, pressing the RES (+) switch
once resumes the function to the
previous state.
DPF REGENERATION SWITCH
(1) DPF Regeneration Switch
(A) Activation (B) Deactivation
ACTIVATION (UPPER PORTION OF
SWITCH)
Perform the following instructions
when the regeneration warning lamp
comes on: (see page 4-18.)
1. Park the tractor on a at surface.
2. Idle the engine.
3. Depress the brake pedals and
stop the vehicle.
4. Put all shift levers into the neutral
position.
5. Run the engine for 3 to 4 minutes.
Then, press the activation portion
of the regeneration switch for ap-
prox. 2 seconds.
DEACTIVATION (LOWER PORTION
OF SWITCH)
Do not press the deactivation portion
of the switch while the regeneration
process is activated.
However, the switch can be set to
the deactivation position to stop the
regeneration process in emergency.
IMPORTANT
The PTO cruise is not deac-
tivated when depressing one
of the brake pedals with the
brake pedals disconnected
from each other.
•
NOTE
The illumination timing of the
regeneration process lamp may
differ depending on the DPF
temperature.
•
6. The regeneration warning lamp
goes off and the regeneration pro-
cess lamp blinks.
Before resuming your work, wait
for approx. 30 to 40 minutes until
the regeneration process is com-
pleted.
To Next Page
Loading...
