(1) P.T.O Shaft Cover (2) P.T.O Shaft Cap
WHEN OPERATING THE P.T.O
1. Make sure the tractor is completely
stopped, gears are in neutral and
all moving components have com-
pletely stopped before connecting,
disconnecting, adjusting, clean-
ing or servicing any P.T.O driven
equipment.
2. Keep the P.T.O shaft cover in place
at all times. Replace the P.T.O
shaft cap when the shaft is not in
use.
H23O121a
3. Before installing or using P.T.O
driven equipment, read the man-
ufacturer's manual and review the
safety labels attached to the equip-
ment.
WARNING
Before driving an implement
through the PTO, always make
sure that all bystanders are
well away from the tractor.
When using the PTO drive
with a stationary tractor, al-
ways make sure that the gears
are in neutral and that the
parking brake is applied.
Before starting up any PTO-
driven implement hitched to
the three-point linkage, lift the
implement to its full height
and check that at least 1/4 of
the total length of the tele-
scopic section of the drive
shaft is engaged.
•
•
•
WARNING
Ensure that implements and
attachments are properly in-
stalled and that the tractor and
implement PTO RPM ratings
match.
•
To Next Page
Loading...
