Kioti DK6010 - Cautions for Decal Maintenance

1
-
31
1
-
30
SAFETY PRECAUTIONSDK6010
1
1
-
31
1
-
30
SAFETY PRECAUTIONSDK6010
(8) Part No.: T4930-52311
WARNING
To prevent accident from
implement operation:
1. For an implement for pulling or
pushing force, attach it to the
draw bar only.
2. For an implement designed to
use the 3-point hitch, use the
3-point hitch only.
To prevent injury accident
from PTO operation:
1. Keep all the protective parts in
their original locations.
2. Keep your hands, feet and clothes
away.
3. Before disengaging the PTO and
implement, make sure to stop the
engine. Also, depress the brake
pedals and apply the parking brake
before repairing or servicing the
tractor or implement. If parking on a
slope, chock the wheels.
(9) Part No.: F6800-29112
This tractor is equipped with a DPF(Diesel Particulate Filter).
Use the CJ-4 grade Engine oil. Otherwise, cause DPF failure.
1. Park to Safety Area and Clear Around Exhaust
Pipe.
2. Operating Condition
1) Depress brake pedal and lock it.
2) Put gearshift lever in neutral position.
3) Hand/Foot Accel. Pedal “Idle Min”.
4) Warm up the engine for 1~2 minutes.
5) Do not depress clutch pedal.
6) Press switch over 2 Seconds.
3. Then RPM automatically increase and decrease
until Regen is completed.
4. Normally, it will take 30~40 minutes.
Regeneration
Underway Lamp
1. When DPF starts to regenerate, you can see it.
2. When on regeneration, Do not touch the part
of DPF because it is very hot.
3. Keep Flammables materials and people away
from exhaust pipe.
4. Please keep higher 1700rpm to finish regen
fully until underway lamp is off.
When you see
this warning
Lamp
WARNING
TO AVOID POSSIBLE INJURY, DEATH OR LOSS OF
PROPERTY FROM A MACHINE RUNAWAY
½G~GGGSGGGGG
GGGGGGGUG
½GiGGGSGGGGGG
GGGGUG
4182-53191
(10) Part No.: T4182-53191
CAUTIONS FOR DECAL MAIN-
TENANCE
Safety decals are attached to the
tractor for safe operation. Make sure
to follow the instruction on the decals
as well as the following instruction:
CAUTION
Keep the decals clean and intact.
If any decal is dirty, wash it with
soap and dry with a soft cloth.
Never use a solvent, such a
thinner or acetone, since it can
ruin the decals.
Do not spray high-pressure wa
-
ter directly onto the decal. The
decal may be damaged.
•
•
•
TD210-EEC인증용-DK6010H,DK6010C,DK631 31 2018-04-20 오후 1:20:45