5
-
28
DK6010
DISCONNECTION
1. Make sure to stop the engine be-
fore disconnecting it.
2.
Release any residual pressure in the
hydraulic hoses of the implement
and tractor by operating the double
acting valve lever 4 to 5 times.
3. Remove any foreign material
around the couplers.
4. Lower the implement on the ground
or remove any external load applied
to the implement. Disconnecting
hoses while outer load is applied to
the implement is very difficult and
dangerous due to the pressurized
uid in the hose.
5. Remove the male coupler by push-
ing the female coupler boss back-
ward.
6. Close the dust-proof cover of the
female coupler. Wrap the male cou-
pler of the implement with a plastic
bag to prevent contamination.
WARNING
Never connect or disconnect
the implement hydraulic hoses
while the pressure in it is not re-
leased or the engine is running.
It is hard to connect and discon-
nect the hose and hydraulic
fluid can be sprayed from the
hose, and get into your eyes or
skin.
Sto p the e ngi ne a nd w ear
protective glasses and gloves
before work.
•
•
To Next Page
Loading...
