M55O626A
Refer to the chart below as to install-
ing of an universal joint.
(1) PTO Cover
(A) Allowable Angle Of Universal Joint: 50˚
Allowable angle of universal joint
50˚
The type of PTO shaft
SAE 1-3 / 8" 6 splines
WARNING
Before starting up any PTO-
driven implement hitched to
the three-point linkage, lift the
implement to its full height
and check that at least 1/4 of
the total length of the tele-
scopic section of the drive
shaft is engaged.
•
To Next Page
Loading...
