HOW TO USE QUICK-TURN FUNCTION
1. To activate the quick-turn function,
press the switch downward.
2. When operating the switch to acti-
vate the quick-turn function, make
sure that the front wheels are in
the straight ahead position.
3. As a safety measure, the quick-
turn function cannot be activated
when the range shift lever is set
to the high speed position and the
vehicle speed is over 6 km/h.
4. Make sure to set the switch to the
2WD or 4WD position before leav-
ing the eld.
5. Be sure to select the 2WD during
driving, as 4WD or quick-turn can
cause an unexpected accident
during driving.
6. Never make a sharp turn during
driving.
4WD OPERATION
The 4WD function is used to in-
crease traction power by driving the
front and rear wheels (4 wheels). To
engage the 4WD, press the upper
section of the 4WD switch. As the
4WD operation is performed by hy-
draulic pressure, a simple operation
of the switch can control it.
The 4WD function is useful under the
following conditions:
1. When strong traction force is re-
quired in a humid area.
2. When towing a trailer or using a
loader.
3. When working on sand.
4. When the tractor is pushed forward
by repulsive force from the rotary
tiller on hard soil.
5. When tilling a eld or moving over
a eld bank.
CAUTION
To avoid accidents:
Do not activate the 4WD func
-
tion while driving on a road.
The 4WD should not be used
on a paved road as tires can
be worn faster.
While the 4WD is engaged,
dr iv e th e vehicl e with l ow
speed as steering and braking
characteristics may differ.
The 4WD can be activated even
while the vehicle is moving.
However, noise or shift shock
may occur during 4WD engage-
ment in this case. To ensure
safe driving, it is recommended
to engage the 4WD after stop-
ping the machine completely.
•
•
•
To Next Page
Loading...
