Kone NanoSpace - Page 103

KONE NanoSpace™
Owner’s Manual
102 (196) OM-01.03.086
(B) 2016-01-11
© 2014 KONE Corporation
All rights reserved.
13 Move the plug of the XL8 connector
from position 2 to position 1.
1. Normal position
2. Test position
14
Push the overspeed governor test
button to reset the OSG.
15 Make a car call upwards from the
maintenance access panel: the
elevator car must not move.
NOTE! The safety gear switch must
cut the safety circuit.
16 Switch on the Recall Drive Feature
(RDF).
POS 270.
17 Release the safety gear by driving
upwards
on RDF.
18 Drive the elevator car on RDF to a
suit
able position for going to the car
roof.
Step Action Illustration/Note
1
12
1027270.wm
f
1
1
08986
1.wmf