KONE NanoSpace™
Owner’s Manual
177 (196) OM-01.03.086
(B) 2016-01-11
© 2014 KONE Corporation
All rights reserved.
Testing car roof safety buffers
Table E1. Positions of the safety devices and capability of each
driving mode.
Buffers on car roof (1/2) Inspection Normal
Down Down No Yes
Up Up Yes No
Up Down No No
Down Up No No
Step Actions Illustration/Note
1 Go to the MAP.
2 Open the MAP.
3 Switch on the RDF (270).
4 Drive the elevator car on RDF so that
you have an a
ccess to the car roof.
5 Use the emergency opening key to open
the landing door
.
6 Check that the elevator car is in suitable
position for a
cce
ssing the car roof.
Reposition the elevator car with RDF if
needed until the position is suitable.
7 Press the car roof stop switch.
8 Close the landing door and check that it
is mechanically locked.
9 Go
to MAP.
Switch off the RDF (270).
10 Close and lock the MAP.
To Next Page
Loading...