Loading a single bank
You can load a single bank of User data (User Programs, User
Styles, Performances) with a single operation. A bank corre-
sponds to a STYLE or PROGRAM/PERFORMANCE button.
1. If loading from floppy disk, insert the disk into the disk
drive.
2. Select the source disk, using the F1 button. You can
select a disk device in this order: HD ➛ FD ➛ CRD ➛
HD…
3. Use the E-H (Scroll) buttons (or the TEMPO/VALUE
controls) to select the “.SET” folder containing the data
you wish to load.
Move the folder to the first line of the display. If the
folder you are looking for is in another folder, use the F3
(Open) button to open it. Use the F4 (Close) button to
go back to the parent folder.
4. Press F3 (Open) to open the “.SET” folder. A list of User
data appears (Global, Performance, Program, Style).
5. Use the E-H (Scroll) buttons (or the TEMPO/VALUE
controls) to move the data type you are looking for to
the first line of the display.
6. Press F3 (Open) to open the selected folder. A list of
User banks appears.
7. Use the E-H (Scroll) buttons (or the TEMPO/VALUE
controls) to move the desired bank to the first line of the
display.
8. Press F2 (Load) to confirm the file selection. The list of
User banks in memory appears.
In the page above, the previously selected Style bank will
be loaded into the bank 1 (USER1 button) in memory.
The existing Styles in memory will be deleted and over-
written.
9. Scroll the available locations in memory, using the E-H
(Scroll) buttons (or the TEMPO/VALUE controls).
10. When the target bank is selected (i.e., it is in the first line
of the display), press F2 (Load) to load the bank. The
“Are you sure message” will appear. Press ENTER to
confirm, or EXIT to abort.
Warning: After confirming, all User data contained in the
bank in memory is deleted.
When the operation is completed (the “Wait” indicator
disappears), the source page comes back in the display,
and you may perform further loading operations.
Loading a single item
You can load a single User item (i.e., a single User Program, a
single User Style, or a single Performance) with a single oper-
ation.
1. If loading from floppy disk, insert the disk into the disk
drive.
2. Select the source disk, using the F1 button. You can
select a disk device in this order: HD ➛ FD ➛ CRD ➛
HD…
3. Use the E-H (Scroll) buttons (or the TEMPO/VALUE
controls) to select the “.SET” folder containing the item
you wish to load.
Move the folder to the first line of the display. If the
folder you are looking for is in another folder, use the F3
(Open) button to open it. Use the F4 (Close) button to
go back to the parent folder.
Device Type
HD Hard disk
FD Floppy disk
CRD Flash Card
PERFORM |
PROGRAM
STYLE |
FD LOAD OPEN CLOSE
Disk:Load
USER01.STY |
USER02.STY
USER03.STY |
FD LOAD OPEN CLOSE
Disk:Load
Device Type
HD Hard disk
FD Floppy disk
CRD Flash Card
User01 |
User02
User03 |
FD LOAD OPEN CLOSE
Disk:Load
To Next Page
Loading...
Need help?
General
