Kyocera TASKalfa 650c

7 COMMAND CENTER ADMINISTRATOR MODE
114 Setting up From COMMAND CENTER
3) Actual Frame
This displays the actual frame type of the equipment.
 Setting up AppleTalk
You can set the protocol to enable communication over AppleTalk. AppleTalk must be configured to enable AppleTalk
printing from Macintosh computers.
1) Enable Apple Talk
Select whether the AppleTalk protocol is enabled or disabled. Enable this when configuring AppleTalk printing.
2) Device Name
Enter the device name of the equipment that will be displayed in the AppleTalk network.
3) Desired Zone
Enter the zone name where the equipment will connect — if required. If you leave an asterisk in this box, the
equipment will connect to the default zone.
 Setting up Bonjour
In Bonjour, you can enable or disable the Bonjour networking that is available for Mac OS X.
1) Enable Bonjour
Select whether Bonjour is enabled or disabled.
2) Link-Local Host Name
Enter the DNS host name of this equipment.
3) Service Name
Enter the device name of this equipment that will be displayed in the Bonjour network.
1
2
3
1
2
3