7 COMMAND CENTER ADMINISTRATOR MODE
116 Setting up From COMMAND CENTER
Setting up DNS Session
In DNS Session, you can specify the DNS server to enable the FQDN (Fully Qualified Domain Name) rather than the IP
address on specifying each server address such as SMTP server, POP3 server, and LDAP server.
When the DNS service is enabled and the DNS server supports the dynamic DNS service, Set the DDNS Session as
well.
P.117 “Setting up DDNS Session”
1) Enable DNS
Select whether the DNS server is enabled or not.
2) Primary DNS Server Address
Specify the IP address of the primary DNS server when the DNS service is enabled.
3) Secondary DNS Server Address
Specify the IP address of the secondary DNS server when the DNS service is enabled, as you require.
4) Primary DNS Server Address(IPv6)
Specify the IP address of the primary DNS server when the DNS service is enabled in IPv6.
5) Secondary DNS Server Address(IPv6)
Specify the IP address of the secondary DNS server when the DNS service is enabled in IPv6, as required.
When the [Obtain a Domain Server Address automatically] option is enabled in the TCP/IP settings, the server address
of the primary and secondary DNS server addresses can be obtained using the DHCP server.
P.109 “Setting up TCP/IP”
To Next Page
Loading...
