Kyocera TASKalfa 650c

7.COMMAND CENTER ADMINISTRATOR MODE
Setting up From COMMAND CENTER 185
7 COMMAND CENTER ADMINISTRATOR MODE
 Setting up NetWare Print
In NetWare Print, you can set the NetWare print options to enable the Novell print service.
1) Login Name
Enter the print server name that is created in the NetWare file server.
2) Password
Enter the password that is set to the print server, if required.
3) Print Queue Scan Rate
Enter how frequently to scan the print queues for print jobs. This should be entered in seconds. You can enter between
1 to 255.
 Setting up Email Print
In Email Print, you can set how the Email print jobs are printed.
1) Enable Print Header
Select whether to print the Email header when receiving Email print jobs.
2) Enable Print Message Body
Select whether to print the body message when receiving Email print jobs.
3) Maximum Email Body Print
Enter the maximum number of pages to print the body strings of the received Email print job. You can enter between 1
to 99.
4) Enable Print Email Error
Select whether to print the report when an error occurs for Email printing.
5) Enable Email Error Forward
Select whether to send an error message to an administrative Email address when Email printing cannot be
completed.
6) Email Error Transfer Address
If enabling the Email Error Forward, enter an administrative Email address where the error message is sent.
7) Enable Partial Email
Select whether to print Email jobs that are partially received.
8) Partial Wait Time
Enter how long this equipment should wait before printing a partial Email job. This should be entered in hour.
9) MDN Reply
Select whether to send an MDN message reply or not when the equipment receives an Email print job with an MDN
request.
1
2
3
1
2
3
4
5
6
7
8
9