7.COMMAND CENTER ADMINISTRATOR MODE
Setting up From COMMAND CENTER 117
7 COMMAND CENTER ADMINISTRATOR MODE
Setting up DDNS Session
In DDNS Session, you can enable the Dynamic DNS service if the DNS server supports the dynamic DNS.
When using the security in DDNS, if the difference between the time set in the server, in which Windows DNS
record is to be updated, and the one set in the equipment exceeds the time stated in the account policy of the
server, the DNS update using the security will fail.Check the time set for the DNS server and match it with the one
set for the equipment.
When using DDNS and the IP address is assigned using DHCP, enable “006 DNS Servers” and “015 DNS Domain
Name” in the DHCP Server’s Scope Options or Server Options.
When using DDNS, make sure the “Allow dynamic updates?” option is set to “Yes” (for Windows 2000 Server) or
“Nonsecure and secure” (for Windows Server 2003) for the Forward Lookup Zones and Reversed Lookup Zones. If
the setting of Windows Server 2003 is “Secure” mode or “None” for this DDNS function, you need to set the correct
primary login name and primary password to update the DNS server by DDNS. If you do not want to use DDNS
such as managed by primary and secondary login name and password, you need to add the equipment’s host
name manually in the Forward and Reversed Lookup Zone.
Forward Lookup Zones
(Windows 2000 Server)
Reversed Lookup Zones
(Windows 2000 Server)
To Next Page
Loading...
