7 COMMAND CENTER ADMINISTRATOR MODE
196 Maintenance From COMMAND CENTER
6
In each box displayed, click [Browse] to locate the setup files to be uploaded.
At the left of each box, the file name will be displayed. Be sure to specify the same file for each box.
The files for uploading are provided for each client software.
Driver Files — Contact your dealer for information about obtaining these files.
Macintosh PPD Files — Provided in the “MacPPD” folder of the Client Utilities CD-ROM.
Unix Filters — Provided in the Client Utilities CD-ROM.
Point And Print — Contact your dealer for information about obtaining these files.
7
Click [Upload].
Specified files are uploaded in this equipment.
Removing the client software
You can remove client software from COMMAND CENTER so that it can no longer be installed from COMMAND
CENTER.
The printer drivers for Point and Print that had been uploaded cannot be deleted. However, you can upload new printer
drivers to overwrite them.
Removing the software from COMMAND CENTER
1
Access COMMAND CENTER in the administrator mode.
P.100 “Accessing COMMAND CENTER Administrator Mode”
2
Click the [Maintenance] menu and [Remove Software] submenu.
The Remove Software submenu page is displayed.
To Next Page
Loading...
