Kyocera TASKalfa 650c

7 COMMAND CENTER ADMINISTRATOR MODE
290 Setting up User Management
 Setting up User Authentication for Scan to Email
When the User Authentication for Scan to Email is enabled, users must enter the user name and password before
performing Scan to Email.
You can select either the SMTP or LDAP for User Authentication for Scan to Email.
 SMTP Authentication
This equipment can be managed using the SMTP Authentication.
When this is configured, users must enter the user name and password that is registered in the SMTP server to
perform Scan to Email on the control panel of this equipment.
 P.290 “Enabling User Authentication for Scan to Email (SMTP)”
 LDAP Authentication
When your network manages the network users using the LDAP, this equipment can be managed using the LDAP
Authentication.
When this is configured, users must enter the user name and password that is registered in the LDAP server to
perform Scan to Email on the control panel of this equipment.
 P.293 “Enabling User Authentication for Scan to Email (LDAP)”
When the User Authentication for Scan to Email is enabled, the Email Notification may not be sent to the administrator.
Make sure to set the login name and password in the SMTP Client settings.
 P.123 “Setting up SMTP Client”
Enabling User Authentication for Scan to Email (SMTP)
1
Click the [User Management] tab and the [Authentication] menu.
The login page is displayed.
2
Enter the administrator password and click [Login].
The Authentication page is displayed.