Kyocera TASKalfa 650c

7.COMMAND CENTER ADMINISTRATOR MODE
Setting up From COMMAND CENTER 175
7 COMMAND CENTER ADMINISTRATOR MODE
7) Default Body Strings
Enter the body text that will be automatically entered in the [Body] box when users operate Scan to Internet Fax from
the touch panel. This sets only the default body text, so that it can be changed on each operation by users.
8) Body Strings Transmission
Select whether the body strings will be sent or not.
 Setting up Printer settings
In the [Printer] submenu in the [Setup] menu, an administrator can configure how the printer works and the printer options
needed for the raw print jobs.
Setting the printer settings
1
Access COMMAND CENTER in the administrator mode.
 P.100 “Accessing COMMAND CENTER Administrator Mode”
2
Click the [Setup] menu and [Printer] submenu.
The Printer submenu page is displayed.
3
In the Printer submenu page, set the Printer settings as required.
To set the Printer Settings, see the following:
 P.176 “Setting up General Setting”
 P.177 “Setting up Default Raw Job Setting”
 P.178 “Setting up Raw Job Setting”
4
Click [Save].
The confirmation dialog box appears.
If you want to restore the current settings without saving the changes, click [Cancel]. Clicking [Cancel] cannot
restore the defaults. This can only clear the changes and restore the current settings before saving the
changes.