Kyocera TASKalfa 650c

8 OPTION SETUPS
300 Setting up IP Security Function
 Setting up IPsec
The administrator can set up the IP security function on the following COMMAND CENTER menu:
[Setup] menu > [Network] submenu > [IP Security]
Setup procedure of IP security function
1
Access the COMMAND CENTER administrator mode.
 P.100 “Accessing COMMAND CENTER Administrator Mode”
2
Click [Setup], and then [Network].
 P.107 “Setting up Network settings”
3
Click a link on the [Network] submenu or scroll down the menu and click [IP Security].
The IP Security setting page is displayed.
On the IP Security setting page, you can set up the items below.
Enable IPsec — Selects whether to enable or disable IPsec.
 Enable — Select this to enable IPsec.
 Disable
— Select this to disable IPsec.
Policy — Selects a policy to be used for IPsec.
You must select a policy to enable IPsec. Policies must be set according to the IPsec environment that you use
and must be registered into this equipment in advance. For instructions on how to register policies, see the
following page:
 P.301 “Registering policies”
IPsec menu — Select this to access each menu for setting the detailed functions of the IPsec. When you select
this menu, the registration contents of each menu are displayed in a list. These contents can be modified or
deleted. For instructions on how to operate with each menu, see the following page:
 P.301 “Registering policies”
4
Click [Return] after you complete the setting.
The IP Security Setting page is closed.
5
Click [Save].
The confirmation dialog box appears.