8 OPTION SETUPS
Setting up IP Security Function 299
Setting up IP Security Function
With the IP security function, you can enable data encryption communication using IPsec (IP Security Protocol). On the IP
security setup menu, you can switch whether to enable or disable the IPsec function, or set the registration, modification or
deletion of filters, IKE keys, profiles and policies used for IPsec.
P.300 “Setup procedure of IP security function”
The IPSec Enabler GP-1080 (optional) is required to enable the IP security function.
IP security setup menus on the COMMAND CENTER menu are displayed only when the IP security function is
available.
([Administration] tab > [Setup] menu > [Network] submenu > [IP Security])
Only the administrator can set up IP security function.
The normal filtering settings are given priority over IP security filtering.
A fallback function is embedded in the IP security function of this equipment. Fallback occurs automatically from IKEv2
to IKEv1 when this equipment receives a notification message “INVALID_MAJOR_VERSION 5” in a notification
payload in IKEv2 communication.
To Next Page
Loading...
