7 COMMAND CENTER ADMINISTRATOR MODE
120 Setting up From COMMAND CENTER
When the [Obtain a Domain Name automatically] option is enabled in the TCP/IP settings, the domain name can
be obtained using the DHCP server.
P.109 “Setting up TCP/IP”
You can enter only alphanumeric characters and symbols except the following characters for Workgroup.
; : “ < > * + = \ | ? ,
If you use any other characters, a warning message will be displayed.
5) Primary Domain Controller
Specify the server name or IP address of the primary domain controller when this equipment will logon the domain
network.
6) Backup Domain Controller
Specify the server name or IP address of the backup domain controller when this equipment will logon the domain
network, if required. If the Primary Domain Controller is unavailable, the Backup Domain Controller will be used to log
on.
If the wrong primary or backup domain controller is specified, the NETWORK INITIALIZING message will be
displayed for 5 to 10 minutes while this equipment searches for the primary or backup domain controller. In that
case, correct the primary or backup domain controller setting after the NETWORK INITIALIZING message
disappears.
7) Logon User Name
Enter a valid user name to logon to the specified domain.
8) Password
Enter the password for the specified logon user name to logon the domain network.
9) Primary WINS Server
Specify the IP address of the primary WINS server when the WINS server is used to provide the NetBIOS name in
your local area network. This option would be more useful to access this equipment using the NetBIOS Name from a
different subnet.
When the [Obtain a WINS Server Address automatically] option is enabled in the TCP/IP settings, the primary and
secondary WINS server address can be obtained using the DHCP server.
P.109 “Setting up TCP/IP”
10)Secondary WINS Server
Specify the IP address of the secondary WINS server as you require when the WINS server is used to provide
NetBIOS name in your local area network. If the Primary WINS Server is unavailable, the Secondary WINS Server will
be used.
When the [Obtain a WINS Server Address automatically] option is enabled in the TCP/IP settings, the primary and
secondary WINS server address can be obtained using the DHCP server.
P.109 “Setting up TCP/IP”
If “0.0.0.0” is entered for the Primary WINS Server and Secondary WINS Server, this equipment will not use the
WINS server.
11) SMB Signing of SMB Server
Select whether SMB Signing is enabled or disabled when a client accesses this equipment using SMB, such as when
a client accesses the shared folder in this equipment.
- If client agrees, digital signature is done for the communication.
— Select this to use the digital signature to
secure the communication only when a client accesses this equipment with a digital signature. Even if a client
accesses this equipment without a digital signature, the communication is allowed without the digital signature.
To Next Page
Loading...
