7 COMMAND CENTER ADMINISTRATOR MODE
132 Setting up From COMMAND CENTER
Registering or editing SNMP user information
1
Click [New] to create new SNMP user information. Click the desired user name on the
list to edit SNMP user information already registered.
The Create SNMP User Information page is displayed.
2
Select the items below and click [Save].
Context Name — Context name is displayed.
User Name — Enter a user name within 31 characters.
Authentication Protocol — Select an authentication protocol.
HMAC-MD5
— Select this to use HMAC-MD5.
HMAC-SHA — Select this to use HMAC-SHA.
Authentication Password — Enter an authentication password within 31 characters.
Privacy Protocol — Select a protocol for data encryption.
None
— Select this not to encrypt data.
CBC-DES — Select this to use CBC-DES.
Privacy Password — Enter a user information password within 31 characters.
Permissions Level — Select a level for permitting access from SNMP users.
Read Only
— Select this to permit only the reading of data.
Read Write — Select this to permit both the reading and writing of data.
The Create SNMP User Information page is closed and the newly created user information is registered on the
SNMP user information list.
3
Click [OK] to close the SNMP Setup page.
4
Click [Save] on the Network submenu page.
To Next Page
Loading...
