7.COMMAND CENTER ADMINISTRATOR MODE
Setting up From COMMAND CENTER 135
7 COMMAND CENTER ADMINISTRATOR MODE
Setting up Security Service
In the Security Service page, you can install a wireless LAN certificate for authentication with the RADIUS server, install
and export a server certificate to enable SSL and set up its SCEP (automatic installation), install CA certificate, and install
certificates for IEEE802.1X authentication and set up its SCEP.
P.135 “Installing Certificate for wireless LAN”
P.136 “Installing server certificate”
P.146 “Installing user certificate for IEEE802.1X”
P.153 “Installing CA certificate”
Installing Certificate for wireless LAN
When you want to set the IEEE802.1X authentication with the RADIUS server for the optional Wireless LAN Module (GN-
1050), you must install user certificate and CA certificate as required.
This equipment supports CA certificate and User certificate that are in the following encoding formats.
- CA Certificate: DER, BASE64, PKCS#7
- User Certificate: PKCS#12
This equipment supports md5RSA and sha1RSA certificate. Make sure to use the certificate in these algorithms.
For further information about the Wireless LAN, refer to the GN-1050 Operator’s Manual for Wireless LAN Module.
Installing certificate for wireless LAN
1
Click [Security Service].
The Security Service page is displayed.
2
Click [Browse] to select a CA certificate and user certificate file as required. Then click
[Upload].
Certificate installation begins.
Wait until the installation is completed and the Security Service page is displayed.
To Next Page
Loading...
